This installer is for the ratgdo32 & ratgdo32 disco boards. It will not work with the ratgdo v2.5xi boards. If you have an older v2.5x board, please use this installer.
Set WiFi network SSID and Password after installation by connecting a device to ratgdo's hotspot, named Garage Door ABCDEF (where last six characters are unique) and connect a browser to IP address http://192.168.4.1
If you want to use ESPHome check out the ESPHome firmware & GitHub Repo.
For a comparison of available features for the different firmware options, please refer to the feature matrix.
Both ratgdo32 and ratgdo32 disco use a CH9102 USB to Serial chipset. Most modern operating systems that have been tested include the necessary drivers.
Standalone drivers are available. Only install them if needed:
The setup process may take as long as a full minute, so please be patient.